| This kind of WEDM machine tool cuts graphite. The graphite wire cutting machine includes bracket, worktable and clamping plate. When it is used, the wire electrifies the coil. After electrification, it generates gravitation on the pressure plate, and then clamps the thin plate between the pressure plate and the base. Because of the use of electromagnetic force clamping, graphite can be made into a variety of workpiece requirements, and can be processed on the side wall of the workpiece, the operation is also very simple. According to the general hydraulic CNC bending machine die processing Q235 sheet metal to do a brief introduction:
1. First, turn on the power supply, turn on the switch on the control panel, and then start the oil pump, so you can hear the rolling sound of the oil pump. (The machine does not move at this time)
2. Travel conditioning, use must pay attention to conditioning travel, before bending must be tested. When its upper die goes down to the bottom, it must ensure that there is a gap of plate thickness. Otherwise, it will damage the die machine. Travel adjustment is also electric fast adjustment.
3. Choosing the bending groove, the groove with 8 times the width of the plate thickness should be chosen generally. For bending 4mm sheet metal, about 32 grooves should be selected.
4. Back shield adjustments generally have electric quick adjustments and manual fine adjustments, the same way as the shears. |
Location：
